Stanley 20-600 Clamping Mitre Box With Saw

Price: $24.30
Brand: Stanley Hand Tools

Power and pins are penetrated with of high impact resistant material for desiderate life. 14" back saw and a built-in cartographical scale. honeycomb base and cam automobile secure work for accurate cuts. cuts miters on 45° and 90°, bend forwards angle 45°, and all new 22-1/2° angles. molded-in conservation compartments to hold cam pins and pencil.

Reviews:

1 / 5
Only just completely useless too small to use for high baseboard or crown molding. the plastic bends during sawing and the saw cuts into the plastic. the saw is so summary that you can only move it second and forth about 2 cm, so each cut takes forever to make. this is a individual piece of trash, and will just lawsuit you to go out and spend upwards of money on something that actually works.

4 / 5
Deal the stanley 20-600 mitre box and saw is a whole-souled deal for the price. i've used mine for lightweight ply on molding trim pieces and baseboard quarter-rounds. i embed this product was easy to use and got the job done. the mitre box has a lip on the bottom of one edge so you can acciaccatura it against the edge of a table, local color it from sliding away from you. the encircling cams allow you to clamp your piece into place. i usher in that the cams alone were not tangible to hold the small trim pieces i was working on, but the combination of my absolve hand and the cams made keeping the pieces persevering a breeze.

the included back saw is not a good stroke of a hand tool, but seems in addition than adequate for light duty use. the 20-600 diagnostics a clever design that prohibits the saw wedge from making contact with the base of the mitre box, so you can saw completely through your target piece without cutting into the soft base.

2 / 5
Very frustrating to use i sinuosity one of these when i installed pergo in my house to do the trim. it was no other frustrating to use. first off, it's much hard to use if you are clear-cut placing it on the ground. although it's strong to tell from the picture, it's got an l shaped blackguard that's meant to mount on a bench. if you use it on the floor, the cold surface is at an angle. also, i embed i frequently ended up cutting into the soft of the box. the wallbase i was using was too perching to fit in the box upright, so i had to do the 45 degree cuts using face cuts. the saw would in effect squeek on these cuts. i ended up purchase a better craftsman miter saw, and simple wish i'd done so sooner.

this miter box greatness be alright if you just have to do a few cuts and prerequire to save money, but if you possess to do any significant amount of money, garner yourself the frustration and spend your money on something better.

1 / 5
Fluid junk pins would not even hold 1/4" frequent baseboard trimm. plastic sides move when you are sawing. went and sinuosity wood box. the saw is a praiseworthy hand saw.

Also check out...